Articles:

It’s always important to follow the instructions and to test the stain remover on a hidden patch of carpet first..

Allow The Bin to Dry Fully.Once the dust bin has been cleaned,.

it’s very important to allow time for it to completely dry.There are several reasons for this:.Moisture in the bin will attract dirt, dust, and other debris when you use the vacuum.

This will undo all your hard work cleaning the bin.. Any moisture that’s inside the bin could be sucked into the motor, which is dangerous for both you and the vacuum.. A damp bin is a perfect place for mould to grow..The seals are often the slowest part of the bin to dry, so check these areas to make sure there’s no moisture remaining.. 5.

When you’re satisfied that the bin is dry, you can refit it onto the main vacuum body.. To do this, line up the spine onto the runner, then gently push the bin upwards until it clicks into place.

You’ll also need to close the bin lid.. And you’re finished!Put the hose in a sink and rinse it out with cold water.

At the same time, clean any dirt on the hose exterior with a soft cloth.. Add a few inches of water to the sink, along with some washing up liquid.Submerge the hose in the sink and move it around to ensure that the water reaches everywhere.. Rinse the hose thoroughly with cold water, then gently shake off as much as possible..

Finally, allow the hose to fully dry.This can take a long time, but it’s vital the hose is completely dry before you use it again.. Only use cold water when cleaning your vacuum’s hose, as warm water could damage it.. 4.